Pyramax Reflow Oven Spare Parts

BTU Service recognizes the critical importance of maintaining uninterrupted production. Given the operational demands of industrial manufacturing, all equipment requires routine maintenance and timely replacement of key components to ensure optimal performance. At BTU Customer Service, we have identified a recommended inventory of spare parts tailored to each product platform. This proactive approach enables you to maximize equipment uptime and operational efficiency. Below, you’ll find a curated list of parts aligned with your specific equipment type.

Pyramax Nitrogen Configuration Spare Parts:

Electrical:

• Solid State Relay (SSR) – controls on/off time of heaters
• Circuit breaker (heater circuit)
• Intellimax 2 controller
• 24VDC power supply
• Pressure transducer – closed loop convection control
• Blower assembly (HAP plug assembly) – closed loop convection control
• Variable frequency drive (VFD) – closed loop convection control
• Heaters – Some ovens will have a combination of 2.5k and 5.0k Ohm heaters
• Electrical relays
• Relay socket
• Conveyor drive motor
• Heater contactor
• Main contactor
• Thermocouple – temperature control
• Optical Encoder – width adjustment
• Atmosphere sampling solenoid

Mechanical:

• Cooler blower assembly – includes vibration dampers, gaskets, and mounting plates
• Sprockets with bearings and spring clips – conveyor drive system
• Torque limiter – Conveyor Drive System
• Rail Hanger Assembly – adjustable edge rail assembly
• Water flow switch
• Main Nitrogen regulator
• KF50 Vacuum SST centering rings with viton O-ring
• Hose and quick disconnect assemblies
• Sampling tube and connectors – closed loop pressure control
• Paraflex tubing and connectors – Nitrogen distribution and sampling
• Krytox high temp grease – lead screw(s)
• Oil fuchs stabylan – conveyor
• High temperature RTV adhesive

Flux Management Parts:

•  Heat exchangerassembly
• Flux filters – orange and white
• Hose and quick disconnect assemblies
• Pressure transducer
• Blower motor
• Gasketing
• High temperature RTV adhesive

AquaScrub Parts:

• AQSB 300 concentrate solution

Electrical:

• Photo sensor – carboy present
• Pressure transducer – differential pressure
• Load sensor – for waste carboy
• Solenoid – water fill
• Relays
• Waste pump – dumps waste water
• Peristaltic pump – this is the small solvent pump
• Blower motor – Hot air extraction
• Thermocouple

Mechanical:

• Raschig rings
• Dehumidifying coil AQSB
• Wash tank window and gasket
• Hose BUNA-N push-On 1.0ID black
• Brazed plate heat exchanger
• Tygon tubing
• Parflex tubing and fittings
• Pressure regulator
• KF50 sacuum SST centering rings with viton o-ring

Pyramax Air Configuration Spare Parts:

Electrical:

• Solid State Relay (SSR) – controls on/off time of heaters
• Circuit breaker (heater circuit)
• Intellimax 2 controller
• 24VDC power supply
• Blower assembly
• Variablefrequency drive (VFD) – closed loop convection control
• Heaters – some ovens will have a combination of 2.5k and 5.0k Ohm heaters
• Electrical relays
• Relay socket
• Conveyor drive motor
• Heater contactor
• Main contactor
• Thermocouple – temperature control
• Optical Encoder – width adjustment

Mechanical:

• High temperature RTV adhesive
• Sprockets with bearings and spring clips – conveyor drive system
• Torque Limiter – conveyor drive system
• Rail hanger assembly – adjustable edge rail assembly
• Oil fuchs stabylan – conveyor